2gig Technologies GC3 매뉴얼 - 페이지 3

{카테고리_이름} 2gig Technologies GC3에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 2gig Technologies GC3 4 페이지. Lte cellular radio module
2gig Technologies GC3에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지)

페이지 인쇄

INSTALLING the NEW BATTERY

Be careful when handling the battery to avoid

scratching the surface. Scratches on the battery

could render the battery not useable. Contact

Nortek Control Customer Support to assist with

a replacement.

1. Take the new battery, and ease it into the

panel back into position clearing TAB 2 then

sliding the battery under TAB 1.

a. The connection wire should be closest to

the side tab, adjacent from Tab 2.

2. Reattach the wired battery pin connector to

the PCB battery connector port.

b. Tuck the wire and ferrite bead in the channel alongside the battery so it sits below the surface

of the battery.

Tuck Bead

3. Re-attach the THIRD HAND and hang the

panel on the wall

NOTE: SKIP this step if your panel is not

mounted.

4. Re-attach any connectors back to the

terminal block if removed when removing

the panel from the wall.

5. Reconnect Power

a. Re-attach the barrel connector to the

barrel jack on the panel if this power

option is used.

b. Re-attach the 2-conductor power

wires to the PWR+ /PWR- screw

positions on the panel's terminal block.

Be sure the correct wires are aligned

with the proper input positions.

Connector should

be located closest

to this side of

the panel.

IMPORTANT: Be certain that the ferrite bead is

properly seated next to the battery connector

terminal to prevent damage to the battery or the

back panel from closing properly.

Third Hand

GND

ZONE 2

ZONE 1

BELL –

BELL +

GND

PWR –

PWR +

-OR-

Re-attach the 2-Conductor

Power Wires (if in use)

Connect the

Barrel Power

Connector

(if in use)