DAW Industries 4P10 KD 매뉴얼 - 페이지 10

{카테고리_이름} DAW Industries 4P10 KD에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DAW Industries 4P10 KD 10 페이지.

페이지 인쇄

Returning Flexion & Extension

Adjustments to Factory Settings

A .

Unscrew and remove the brass Extension Screw (3mm Hex)

from the center of the Flexion Knob .

B .

Using the included Swing Adjustment Wrench (or a 9mm

wrench), gently screw the Flexion Knob clockwise until

it stops . Do not tighten .

C .

Now turn the Knob counter-clockwise 2 full rotations .

D .

While holding the Knob stationary,

screw the Extension Screw back into the Knob (ﬁg. 1)

until one thread shows above the Knob (ﬁg. 2) .

The knee's Flexion & Extension Controls

are now at their factory settings.

Fig. 1

Extension Screw

(3mm hex key)

(Posterior View)

Fig. 2

Extension Screw

(3mm hex)

Flexion Knob

(9mm)

DAW

Industries

Flexion Knob

(9mm)

Swing Adjustment

Wrench

1 Thread showing

above Knob

For Technical Support call (800)242-8669

To Adjust Extension Assist:

A .

Loosen the Pylon Clamp Screw (5mm hex)

and remove the Pylon

Loosen the Lock Nut (12mm wrench)

B .

C .

Turn the Extension Assist Control Screw (5mm hex):

Clockwise to increase extension assist

Counter-clockwise to decrease extension assist

D .

Re-tighten the Lock Nut, Hand Tighten (12mm wrench)

After returning the pylon, re-tighten Pylon Clamp Screw to

11ft-lb (15Nm).

Pylon Clamp Screw

(5mm hex)

11ft-lb(15nm)

Lock Nut

(12mm wrench)

Hand Tighten

DAW

Industries

Adjusting Extension Assist

Extension Assist Control Screw

(5mm hex)

For Technical Support call (800)242-8669