Gage Bilt GB745 매뉴얼 - 페이지 9

{카테고리_이름} Gage Bilt GB745에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gage Bilt GB745 13 페이지. Installation tool
Gage Bilt GB745에 대해서도 마찬가지입니다: 사용자 설명서 (13 페이지)

페이지 인쇄

HEAD

Remove nose assembly from tool before attempting disassembly of head assembly.

Remove end cap (745816). Push against threaded end of piston (745310) to slide it out of head cylinder (745366). Be

careful not to damage threads or cause burrs on polished piston rod surface.

WARNING:

DISPOSE OF HYDRAULIC FLUID IN ACCORDANCE WITH ALL ENVIRONMENTAL LAWS AND REGULATIONS

APPLICABLE TO YOUR AREA.

The re-assembly sequence is the opposite of disassembly. (See Filling and Bleeding instructions.) Apply Loctite® #242

and torque the four button-head cap screws (402479) uniformly to 40 inch lbs. to prevent leakage around the gasket.

401092 - BACK-UP RING

753101 - NOSE FITTING

480124 - NUT

403815 - O'RING

745366 - HEAD CYLINDER

480101 - PINTAIL TUBE

480125 - RETAINING NUT STOP

405889 - O'RING

745310 - PISTON

401119 - BACK-UP RING

402482 - BUTTON HEAD SCREW (2)

S572 - STAT-O-SEAL (2)

A-261 - O'RING

756120 - DEFLECTOR

A-820 - O'RING

401105 - BACK-UP RING

403846 - O'RING

401119 - BACK-UP RING

745816 - END CAP

Rev. 1/14