Gage Bilt GB902 매뉴얼 - 페이지 3

{카테고리_이름} Gage Bilt GB902에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gage Bilt GB902 9 페이지. Hydraulic powerunit

페이지 인쇄

Please read this manual before servicing or using this tool. Complete

with warnings and cautions to prevent severe personal injury or damage

Keep dirt and other foreign matter out of hydraulic systems of tools, hoses, couplers and

powerunit . Do not let hose fittings and couplers contact a dirty floor or unclean working

surface. Foreign matter in hydraulic fluid may cause tool and the powerunits valves to

WARNING

Do not pull fastener unless it is placed in

an assembly, pin will eject forcibly when

pintail breaks off. Severe personal injury

may result.

CAUTION

Insure that nose assembly is properly

matched for the fastener being installed.

WARNING

When operating installation equipment

always wear approved eye protection. Do

not look in front of nose assembly or rear

of tool when installing fastener.

WARNING

Installation of fasteners may exceed

acceptable noise levels. Use approved

hearing protection.

WARNING

Proper pull and return pressures are

important for proper function of

installation tools. Severe personal injury

or damage to equipment may occur

without correct pressures.

NOTE:

the tool.

CAUTION:

malfunction.

Be sure there is adequate clearance for

tool and operator's hands before

proceeding. Keep fingers clear of any

moving parts. Keep fingers clear from

fasteners and installed materials. Severe

personal injury may result.

Always disconnect tool from powerunit

before performing any maintenance to

any tool or nose assembly. Insure that all

connections are proper and there are no

visible leaks from tool or hoses before

connecting to power.

Hydraulic power units that deliver high

pressure for the "PULL" and "RETURN"

and are not equipped with relief valves

are specifically not recommended and

Keep Nose Assemblies clean and free of

WARNING

may be dangerous.

CAUTION

chips and debris.