Gage Bilt GB910 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} Gage Bilt GB910에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gage Bilt GB910 13 페이지. Hydraulic powerunit

페이지 인쇄

NOTE:

Shipped with Pull pressure at 10,000 psi (68,950 kPa) & Return pressure at 6,000 psi (41,370 kPa) for

GB7624. When attaching GB585A set Pull pressure to 5,400-5,700 psi (37,350-39,300 kPa) & Return

pressure 2,200-2,400 psi (15,200-16,500 kPa). Operate Powerunit at 90-120 psi air pressure with a

minimum hose ID of 1/2".

Width.....................................................................13.0 inches................................................................................330mm

Length.....................................................................20.5 inches...............................................................................520mm

Height.....................................................................14.0 inches...............................................................................356mm

Weight (without hyd. fluid)......................................74 pounds...................................................................................33.6kg

Remote Control.................................................................................................... .....Solenoid operated Directional Valve

Motor..................................................................................................................................................3,450 RPM, 1-1/2 HP

Pump.............................................................................................2 - stage, Gear-Piston Type, 50 cu.in./min. @ 5000 psi

Output Pressure..............................................................................................................................Adjustable to 10,000 psi

Reservoir Capacity..................................................................2 gal...........................................................................006m

Operating Temperature (Ambient-min.) ................................. 0° F...........................................................................-18° C

(Hydraulic Fluid-max.) ..........................................................140° F.......................................................................... 65° C

Hydraulic Fluid: Automatic Transmission Fluid (Dexron® III or equivalent- SUS 185 100°F and SUS 50 210° F)

WARNING:

Please read this manual before

servicing or using tool. Comply

with WARNINGS and CAUTIONS to

prevent

damage to tool.

WARNING:

When operating installation equip-

ment always wear approved eye

protection .

TABLE 1

personal

injury or

REV. 10/13