Gage Bilt GBP205A 매뉴얼 - 페이지 3

{카테고리_이름} Gage Bilt GBP205A에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gage Bilt GBP205A 7 페이지. Hydraulic installation tool

페이지 인쇄

PLEASE READ THIS MANUAL BEFORE SERVICING OR USING THIS

TOOL. COMPLETE WITH WARNINGS AND CAUTIONS TO PREVENT

SEVERE PERSONAL INJURY OR DAMAGE THE TOOL.

GAGE BILT TOOLS ARE APPROVED TO INSTALL HUCK®, AVDEL®, CHERRY®, POP®

AND OTHER FASTENERS WHEN USED BY PERSONS WITH SPECIFIC TRAINING OF

BLIND RIVET AND LOCKBOLT INSTALLATION EQUIPMENT.

WARNING

Do not pull fastener unless it is placed in

an assembly, pin will eject forcibly when

pintail breaks off. Severe personal injury

may result.

WARNING

When operating installation equipment

always wear approved eye protection. Do

not look in front of nose assembly or rear

of tool when installing fastener.

WARNING

Installation of fasteners may exceed

acceptable noise levels. Use approved

hearing protection.

CAUTION

Keep Nose Assemblies clean and free of

chips and debris.

NOTE:

CAUTION:

Always disconnect tool from powerunit

before performing any maintenance to

any tool or nose assembly. Ensure that all

connections are proper and there are no

visible leaks from tool or hoses before

Ensure that nose assembly and tip are

properly matched for the fastener being

Be sure there is adequate clearance for

tool and operator's hands before

proceeding. Keep fingers clear of any

moving parts. Keep fingers clear from

fasteners and installed materials. Severe

personal injury may result.

Hydraulic power units that deliver high

pressure for the "PULL" and "RETURN"

and are not equipped with relief valves

are specifically not recommended and

WARNING

connecting to power.

CAUTION

installed.

WARNING

may be dangerous.