Gage Bilt GBP205A 매뉴얼 - 페이지 4

{카테고리_이름} Gage Bilt GBP205A에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gage Bilt GBP205A 7 페이지. Hydraulic installation tool

DESCRIPTION

The GBP205 and the GBP205A are hydraulic installation tools designed specifically for the efficient

installation of a wide range of blind rivets and lockbolt fasteners thru 3/8" diameter, and the installation

of interference fit Hi-Lite® pins. It weighs just under 4 lbs. and can be operated in any position with one

hand. It has a .750 rivet setting stroke.

The GBP205 installation tool operates on hydraulic pressure developed by the GBP940 Powerunit, set

at 5600 psi maximum PULL pressure and 2400 psi maximum RETURN pressure. The tool comes

equipped with 12 feet of hydraulic hoses and couplings, actuator and cord. The GBP205A installation

tool operates on hydraulic pressure developed by the GBP910A Powerunit set at 5600 psi maximum

PULL pressure and 2400 psi maximum RETURN pressure. The tool comes equipped with 12 ft. hydraulic

hoses and couplings, air trigger and tubing.

ALL GBP HYDRAULIC INSTALLATION TOOLS ARE COMPATIBLE WITH HUCK POWERIG'S. NOSE

ASSEMBLIES ARE NOT FURNISHED WITH THE RIVETER AND MUST BE ORDERED SEPARATELY.

OPERATION

When the tool is connected to a Powerunit, operation is controlled by a trigger or switch in the handle.

To send the signal, the GBP205A incorporates an air trigger; the GBP205 an actuator. When the button

is depressed, a directional valve in the Powerunit directs fluid to the front side of the piston forcing it

and the nose assembly collet rearward. This action causes the jaws to clamp on the fastener pintail and

pull the material together. During a lockbolt installation sequence, the anvil is forced over the collar,

swaging it into locking the grooves of the fastener. Further force breaks the pintail off approximately

flush with the collar. The pull-in sequence is started in the same manner, but the pull-in mandrel may

be grabbed a number of times. Releasing the trigger allows the operator to advance the tool on the pin

for installations that require greater than .750 stroke.

When the piston nears the end of its stroke it exposes flats on the back of the unloading valve. These

flats "dump" fluid back to the Powerunit tank. When the button is released the directional valve reverses

fluid flow to the back of the piston and pushes the nose assembly off to the swaged fastener. The spent

pintail is forced out the back of the nose assembly with the insertion of the next fastener.

The performance of any tool depends upon the practice of good maintenance.

Following these minimal requirements for service and care will extend the life of your tool.

*Only use a hydraulic power source equipped with relief valves and pressures set within specified limits.

Consult Powerunit Manual for procedure to set Pull and Return pressures.

*Keep hydraulic system free of dirt. Avoid letting couplers contact a dirty floor.

*Do not use as a hammer to force fasteners into holes or otherwise abuse tool.

*Proper care by operators is necessary in maintaining full productivity and reducing down time.

WARNING

Be sure Powerunit is disconnected before cleaning, or when replacing worn or damaged components.

Severe personal injury may occur if power source is not disconnected.

Covered under Patent No. 5,371,933