Gage Bilt GB2581-750 매뉴얼 - 페이지 5

{카테고리_이름} Gage Bilt GB2581-750에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gage Bilt GB2581-750 10 페이지.

DESCRIPTION

WARNING:

THE BALANCE OF THIS TOOL IS DESIGNED FOR HORIZONTAL USE AND IS NOT SUITED FOR

ANY OTHER APPLICATIONS. GAGE BILT WILL BE PLEASED TO ADVISE FOR YOUR SPECIFIC

APPLICATION.

The GB2581-750 is a hydraulic installation tool. It weighs 6 lbs. 10 oz. (3.0 kg). It has a .750" (19mm) rivet

setting stroke and a rated pull load of 10,700 lbs (47.59kN) @ 7,400 psi. (510.2 bar).

Normal operating pressure is set at 7,400 psi. (510.2 bar) PULL pressure and 3,200 psi. (220.6 bar) RETURN

pressure, enabling the tool to pull all the fasteners listed on the selection chart without adjusting pressures.

Powerunit may be set to the pressures only needed to pull your specific fastener using 942280 pressure

setting gauge. The tool comes equipped with 12' hoses and electric cord kit complete with quick

disconnects.

NOSE ASSEMBLIES ARE NOT FURNISHED WITH THE TOOL AND MUST BE ORDERED SEPARATELY.

MAINTENANCE

WARNING:

EXCESSIVE CONTACT WITH HYDRAULIC FLUID AND LUBRICANTS SHOULD BE AVOIDED.

WARNING:

MAINTENANCE PERSONNEL

WARNING:

DISCONNECT TOOL FROM ITS POWER SOURCE BEFORE PERFORMING MAINTENANCE.

WARNING:

BE SURE POWERUNIT IS DISCONNECTED BEFORE CLEANING OR WHEN REPLACING WORN

OR DAMAGED COMPONENTS. SEVERE PERSONAL INJURY MAY OCCUR IF POWER SOURCE

IS NOT DISCONNECTED.

The performance of any tool depends upon good maintenance practices. Following these minimal

requirements for service and care will extend the life of your tool.

*Only use a hydraulic power source equipped with relief valves and pressures set within

specified limits.

*Keep hydraulic system free of dirt. Avoid letting couplers contact a dirty floor.

*Do not use as a hammer to force fasteners into holes or otherwise abuse tool.

*Proper care by operators is necessary in maintaining full productivity and reducing downtime.

*Check tool, all hoses and all couplings daily for damage or air/hydraulic leaks. Tighten or replace (if

necessary).

IMPORTANT:

Be sure to use thread sealant on all hydraulic fittings, Loctite® 30534 or similar Teflon® infused pipe

dope is recommended.

however, pieces may enter the hydraulic system and cause malfunction and damage. Use 1 1/2 wraps

of tape on each thread. Cut off all loose tape ends. Tighten until fitting feels snug and then go 1/2 to a

full turn past that point.

MUST

READ AND UNDERSTAND ALL WARNINGS AND CAUTIONS.

CAUTION:

Teflon tape is an excellent thread sealer. If it not properly applied,

CAUTION:

Over tightening can easily distort the threads.

10/13