Gage Bilt GB713 원본 사용 설명서 - 페이지 13

{카테고리_이름} Gage Bilt GB713에 대한 원본 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gage Bilt GB713 18 페이지.
Gage Bilt GB713에 대해서도 마찬가지입니다: 설치 매뉴얼 (14 페이지), 원본 사용 설명서 (20 페이지)

페이지 인쇄
Gage Bilt GB713 원본 사용 설명서
WARNING:
Disconnect tool from its power source before actuator removal or installation. Severe personal injury may
occur if power source is not disconnected.
CAUTION:
Air actuator assy can break if not careful.
CAUTION:
Do not over tighten air actuator assy. Snug tighten only.
REMOVING 704130 AIR ACTUATOR ASSY
1.
Insert a 5/8" (15.9 mm) open end box wrench around air actuator assy (704130).
2.
Loosen the air actuator assy (704130).
3.
Remove wrench. Unthread and remove the air actuator assy (704130) with fingers
from the handle assy (744129).
INSTALLING 704130 AIR ACTUATOR ASSY
1.
Apply Teflon® tape onto threads of air actuator assy (704130) one to two wraps.
2.
Thread the air actuator assy (704130) all the way into handle assy (744129) with fingers.
3.
Insert and turn 5/8" (15.9 mm) wrench and snug tight approximately 1/4-1/2 turn.
GB713
OVERHAUL
AIR ACTUATOR
13
7/11 REV 6/16