Gage Bilt GB7624 설치 - 페이지 9
{카테고리_이름} Gage Bilt GB7624에 대한 설치을 온라인으로 검색하거나 PDF를 다운로드하세요. Gage Bilt GB7624 9 페이지. Hydraulic tool
Gage Bilt GB7624에 대해서도 마찬가지입니다: 원본 사용 설명서 (20 페이지)
페이지 인쇄HIGH TENSILE PULL TYPE
BLIND OVERSIZE MANDREL
C50L® AND BOM ® ARE REGISTERED TRADEM ARKS OF ALCOA INC.
GAGE BILT CERTIFIES THE GB7624 WILL INSTALL THE ABOVE FASTENERS
NOTE: THE LAST 2 DIGITS OF THE NOSE ASSEMBLY REPRESENTS THE LENGTH THE NOSE
TEFLON® IS A REGISTERED TRADEMARK OF E.I. DUPONT DE NEMOURS CO. LUBRIPLATE® IS A REGISTERED TRADEMARK OF FISKE BROTHERS REFINING CO. LOCTITE® IS A REGISTERED
TRADEMARK OF HENKEL CORPORATION.
S/N: 1140 AND ABOVE
PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.
GB7624 SELECTION CHART
FASTENER
DIA. NOSE ASSEMBLY
LOCKBOLT
5/8"
3/4"
C50L®
5/8"
BOM®
3/4"
5/8"
HP8
3/4"
HP10.9
16mm
ASSEMBLY EXTENDS FROM THE TOOL. (I.e. -25 = 2.5 inches)
Seller warrants that all goods covered by this catalog will conform
to applicable specifications and will replace or repair, F.O.B. our plant, any
goods providing defective from faulty workmanship, or material, for 6
months from date of shipment
Said warranty to remain in effect if, and only if, such goods are
used in accordance with all instructions as to maintenance, operation and
use, set forth in manuals and instruction sheets furnished by seller.
Sellers obligation under this warranty shall be limited to the repair
or rework of the goods supplied or replacement thereof, at Seller's option,
and in no case is to exceed the invoice value of said goods. Under no
circumstances will the seller be liable for incidental or consequential
damages or for damages incurred by the buyer or subsequent user in
repairing or replacing defective goods or if the goods covered by this
warranty are reworked or subjected to any type of additional processing.
This warranty is void if Seller is not notified in writing of any
rejections or defects within 6 months after the receipt of the material by the
customer.
THIS WARRANTY IS MADE IN LIEU OF ALL OTHER WARRANTIES
EXPRESSED OR IMPLIED, INCLUDING MERCHANTABILITY.
HYDRAULIC PRESSURE REQUIRED
PULL PSI
20-585-41
6200-6400
24-585-46
8800-9200
BOM20-585-41
6200-6400
BOM24-585-46
8800-9200
CONTACT GAGE BILT FOR YOUR REQUIREMENTS
CONTACT GAGE BILT FOR YOUR REQUIREMENTS
WARRANTY
.
9
RETURN PSI
3600-3800
5600-6000
3600-3800
5600-6000
Rev. 2/15
Rev. 12/14