HI tecnologia P7C 연결 매뉴얼 - 페이지 5

{카테고리_이름} HI tecnologia P7C에 대한 연결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HI tecnologia P7C 8 페이지.

User Manual - P7C Controller

Supply

The power supply connector

insert the wire in the terminal block

following picture). Push the screw-driver until open the spring (as indicated by letter B at the following

picture) and, after, insert the wire in the corresponding terminal block

the screw-driver and make sure the connection was completed correctly. To remove the wire is pos-

sible to execute the same procedure indicated by letters A and B of the following picture.

ATTENTION: Electric-shock danger: the bad utilisation may result in fire or death. Read and

follow the instructions indicated at this manual:

Make sure that the cables which will be connected to the power supply are disenergized be-

fore any operation;

Inspect the cable before each utilisation. Do not use if the cable is damaged.

Insert the cable completely into the terminal block

Do not use excessive force to make the connections;

Keep the equipment away from water. Do not use it if wet;

Avoid the overheating. Unwind the cable and do not cover it with any material;

Do not superimpose, drag or put objects above the cable;

1 - Check the Notes and Acronysms List at the beggining of this document

Ref.: PMU107001

is a spring connector

Version: 1.0.07

that does not need a screw to be tightened. To

, use a screw-driver at the smaller hole (as indicated by A, at the

;

Release: 10/20/10

. After this procedure, remove

AC Rack (PWS800)

Terminal

Con-

Signal

nector

Ground

DC Rack (DCC850)

T e r m i n a l

Signal

Connector

Ground

Technical Specifications