Hi-Force ATDP216 사용 설명서 - 페이지 3

{카테고리_이름} Hi-Force ATDP216에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Hi-Force ATDP216 15 페이지. Air driven hydrotest pumps
Hi-Force ATDP216에 대해서도 마찬가지입니다: 사용 설명서 (9 페이지)

페이지 인쇄

Max air consumption:

6 m³ (212scfm) at 7 bar.

A minimum supply pipe bore of ½" diameter is required to allow the pump to operate correctly.

Fluid inlet port:

1" BSP (All models)

Outlet Port:

ATDP63 = ½" NPT

ATDP125 = ½" NPT

ATDP216 = 1.1/8" -12 UNF

Pump operating temperatures:

-20c to +50c

Noise level:

An average A-Weighted sound pressure level of 75dB was measured for undefined workspaces, as per

Directive 2006/42/EC Section 1.7.4.2 (u).

Recommended Fluids:

• De-ironised / De-minerelised water.

• Water Glycol

• Hydraulic oil (see chart below)

Hi-Force tools use 2 grades of hydraulic oil, dependant on the tool.

ISO Hydraulic oil grade

ISO15

ISO46

IMPORTANT:

If in doubt about the suitability of the operating fluid you intend to use, please consult

your nearest Hi-Force office or distributor. Use of unsuitable operating fluids WILL void your

warranty.

Operating Instruction Manual:

OM-ATDP-01

1.0 Specifications

Temperature range Degrees Celcius

From:

-23

-2

From Serial Number:

All

To: