Hi-Force TWE Series 사용 설명서 - 페이지 9

{카테고리_이름} Hi-Force TWE Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Hi-Force TWE Series 20 페이지. Electric torque wrench

페이지 인쇄

Prepared by:-

M.DAVIES

REV NO:-

ECO:-

3.1.2 Measure selection

As soon as the tool is switched on, the

operator can see the factory settings in

Nm and lbf.ft.

The user can't see this when Poti-

setting is selected.

3.1.3 Gear selection

The engaged gear is illuminated on the

display:

Gear 2

Gear 1

3.1.4 TORQUE SETTINGS

The torque setting can be made in two different ways:

1.0

Torque setting with poti setting

Select the required torque from the chart fixed

to the motor housing and adjust the knurl to

those values.

The poti setting is displayed with one post-

decimal place on the display.

e.g. 3,2

This is a factory default setting.

2.0

Torque setting in clear

The display shows the torque in Nm or lbf.ft.

The intervals of the torque setting are

dependent on the rotational speed of the poti

wheel.

Torque setting on the display

(valid for both)

Turn the torque setting dial (2) to the required

value.

After the torque setting dial is stopped, the set

value will flash.

Press the enter button to set this value. If this does

not happen within 3 seconds the value will not be

set and the original value will remain.

The original value also remains after the tool is

switched off.

OPERATING INSTRUCTIONS:

Electric Torque Wrench

Series: TWE

Approved by:-

Page 9 of 20

TDS:-

1399

Date: 25/03/14