Hi-Force TWE Series Інструкція з експлуатації Посібник з експлуатації - Сторінка 9
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Електроінструмент Hi-Force TWE Series. Hi-Force TWE Series 20 сторінок. Electric torque wrench
Друкувати сторінку
Prepared by:-
M.DAVIES
REV NO:-
1
ECO:-
3.1.2 Measure selection
As soon as the tool is switched on, the
operator can see the factory settings in
Nm and lbf.ft.
The user can't see this when Poti-
setting is selected.
3.1.3 Gear selection
The engaged gear is illuminated on the
display:
Gear 2
Gear 1
3.1.4 TORQUE SETTINGS
The torque setting can be made in two different ways:
1.0
Torque setting with poti setting
Select the required torque from the chart fixed
to the motor housing and adjust the knurl to
those values.
The poti setting is displayed with one post-
decimal place on the display.
e.g. 3,2
This is a factory default setting.
2.0
Torque setting in clear
The display shows the torque in Nm or lbf.ft.
The intervals of the torque setting are
dependent on the rotational speed of the poti
wheel.
Torque setting on the display
(valid for both)
Turn the torque setting dial (2) to the required
value.
After the torque setting dial is stopped, the set
value will flash.
Press the enter button to set this value. If this does
not happen within 3 seconds the value will not be
set and the original value will remain.
The original value also remains after the tool is
switched off.
OPERATING INSTRUCTIONS:
Electric Torque Wrench
Series: TWE
Approved by:-
Page 9 of 20
TDS:-
1399
Date: 25/03/14