Aircommand Sparrow Mk4 매뉴얼 매뉴얼 - 페이지 10

{카테고리_이름} Aircommand Sparrow Mk4에 대한 매뉴얼 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aircommand Sparrow Mk4 17 페이지. Air conditioning unit
Aircommand Sparrow Mk4에 대해서도 마찬가지입니다: 소유자 매뉴얼 (17 페이지)

페이지 인쇄

Commissioning of the Unit

1. Turn the power on at the circuit breaker.

2. Press the ON/OFF button and press the MODE button to

select FAN.

3. Cycle through the LOW, MED and HIGH fan speeds checking

that all speeds run.

4. Set mode to COOL, adjust temperature via up/down

buttons to 4˚C below the display temp (ie room temp)

compressor will start within three minutes.

5. Set mode to HEAT, similarly set temperature to 4˚C above

the display temperature. Compressor will start within three

minutes. After a few minutes the fan will start and warm

air will be apparent.

NOTE: Regardless of the mode selected there will always be at

least a 3 minute delay before the compressor starts. If the unit

is turned off it is important that the compressor be given at

least 3 minutes before being re-activated

Maintenance

I. PLENUM FILTERS

The plenum ﬁ lters are the only parts that require routine

maintenance. They must be cleaned periodically to ensure that

they do not become clogged with dust and other particles.

Blocked ﬁ lters must be cleaned frequently to maintain cooling

& heating performance

To clean the two plenum ﬁ lters, ﬁ rst remove them both from

the plenum by pulling them out of the assembly.

Fig 17: Plenum ﬁ lter when removed.

The state of the ﬁ lters can be ascertained from its appearance,

if they appear clogged then they should be cleaned. Generally

the ﬁ lters can be cleaned sufﬁ ciently by tapping them

together to shake loose the dust and particles trapped inside.

WARNING

Airborne particles can pose a health risk, particulalry to young

children and the elderly. Ensure that ﬁ lters are cleaned in a

safe and well ventilated area.

If a more thorough clean is required then the ﬁ lters can be

washed out using warm soapy water. Care must be taken to

avoid ripping the fabric.

The ﬁ lters should be cleaned every two weeks or more when in

use. Prolonged use, higher concentrations of airborne particles

and various other factors may result in the ﬁ lters needing to

be cleaned more often.

Replacement ﬁ lters can be ordered directly from Aircommand.

II. MOUNTING BOLTS

Aircommand suggests that the hold down bolts are initially

checked for tightness within the ﬁ rst 3 months of installation,

and thereafter every 12 months if the van is in constant use.

III. STORAGE

The air conditioner should be run on a routine basis to ensure

the components remain in working order.

If the van is in storage or is to remain unoccupied for an

extended length of time it is recommended that the air

conditioner is allowed to run uninterrupted for 20-30 minutes

once every six months.

For long term storage outdoors, or to protect your Sparrow

from winter storms and weathering when not in use, a

protective cover can be purchased from Aircommand, please

call for details.

IV. WARRANTY CLAIMS

The unit comes with a one year manufacturer's warranty from

date of purchase. It is IMPORTANT that you read and

understand the conditions of the warranty agreement which

are included with the unit.

If you have a claim please contact Aircommand directly on

(+61) 8 8345 8444, alternatively you can fax (+61) 8243 0628 or

email [email protected]

Please have your unit serial number ready.