Daxten Voyager 100 사용자 및 설치 설명서 - 페이지 10
{카테고리_이름} Daxten Voyager 100에 대한 사용자 및 설치 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Daxten Voyager 100 16 페이지. Keyboard, video & mouse extender
Daxten Voyager 100에 대해서도 마찬가지입니다: 설치 매뉴얼 (8 페이지), 브로셔 (2 페이지)
페이지 인쇄CONNECTING UP
The Quick system guide illustrates how the units are interconnected
1. Switch off your PC
2. Connect the local Voyager, keyboard, monitor and mouse as shown in the
appropriate diagram (page 8). You can use the local without mouse, keyboard
and monitor.
3. Connect the UTP cable between the local and remote
4. Connect the mouse keyboard and monitor to the remote.
5. Power up the Remote Unit by connecting the supplied mains adapter and
switching it on.
6. Power on your PC and operating system
7. Check keyboard operates correctly.
8. Check that the mouse functions works right
9. The Remote Unit contains video equalisation circuitry that compensates for loss
in image quality experienced when driving over long cables.
To set the correct level of equalisation there is an adjustment wheel on the rear
side of the remote unit. Select an adjust the range appropriate to the cable length
(these only need to be set once.)
UTP in
Cable Length (m) Switch Position
0 – 30 m
30-50 m
50-70 m
70-100 m
70-100 m
The remote unit (when installed in its final location) may be left permanently powered
up.
Please note that for all practical purposes cable equalisation cannot be exact - the
remote image will never be as sharp as the original. The Voyager's equalisation
system is designed so that is produces very good results on short to medium length
cables and an acceptable quality over longer cables (> 100m/330ft).
10
VGA out
Voyager 100 turning Switch
Cable Length (ft)
0
0-100 ft
1
100-150 ft
2
150-230 ft
3
230-330 ft
4 5 6 7 8 9
230-330 ft
Cable Length distance Setting
.
5 V DC
Switch Position
0
1
2
3
4 5 6 7 8 9