Daxten SCOUTCOMBO - 설치 매뉴얼 - 페이지 3
{카테고리_이름} Daxten SCOUTCOMBO -에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Daxten SCOUTCOMBO - 7 페이지. Soho kvm switch
Daxten SCOUTCOMBO -에 대해서도 마찬가지입니다: 브로셔 (2 페이지), 설치 매뉴얼 (10 페이지)
페이지 인쇄SCOUTcombo
Introduction
Thank you for purchasing the SCOUTcombo Switch. This product will ensure easy and accurate
control over 2 - 4 PCs through a single console. The SCOUTcombo is compatible with USB style
computers. The SCOUTcombo supports high resolutions of up to 2048 x 1536 without any
deterioration of the image quality. Switching between PCs can be accomplished in two ways: through
keyboard Hot Key commands or by using the convenient front panel PC selection buttons.
Product Features
Allows a user to control 2 - 4 computers from one console.
No additional software is required for operation.
Supports Monitor resolutions of up to 2048 x 1536 @ 85Hz.
Supports VGA, SVGA and MultiSync monitors.
Select Push-button or keyboard Hot Key control.
Comes with Auto-Scan mode for convenient automatic switching.
Front panel status LEDs give a clear indication of the active PC.
Hardware Installation
Before connecting your computers and console devices to the SCOUTcombo switch, please ensure
that all devices are powered off. Connecting devices while powered on may lead to damage to your
computers or the SCOUTcombo. Daxten cannot be held responsible for damage caused by
connecting devices that are powered.
1.
Place the SCOUTcombo switch in a convenient location; its small size makes it easy to place
it on the desktop.
Connect the optional power supply to the SCOUTcombo if you have one.
2.
Connecting the console devices:
Connect your monitor's HD 15-pin connector to the SCOUT combo's Monitor port on the rear
panel.
Connect your keyboard and mouse (PS/2 or USB) to the keyboard and mouse connector at the
front of the SCOUTcombo switch. Each port is marked with either a keyboard or mouse
symbol. If you use a USB keyboard and mouse please ensure you have device drivers for
your keyboard and mouse (HID) loaded on your computer if required.
3.
Connecting the computers to the SCOUTcombo with the KVM cable:
Connect the HD 15-pin male connector to the next free PC port on the rear panel of the
SCOUTcombo (labelled PC1, PC2...).
Connect the blue HD 15-pin male connector to the VGA port on your computer.
Connect the purple PS/2 (6-pin MiniDIN) keyboard connector to the PS/2 keyboard port on your
computer.
Connect the green PS/2 (6-pin MiniDIN) mouse connector to the PS/2 mouse port on your
computer.
For a USB keyboard and mouse connect the USB connector to the USB port on your computer.
Power up the first computer, and then verify keyboard and mouse functionality. Repeat this process
for each of the attached computers.
If you find that the keyboard or mouse is not working correctly, verify that all cables are properly
connected, or that the HID drivers are loaded on the computer
Note: USB keyboards with an integrated USB hub are not supported.