Great Little Trading Paddington 매뉴얼 - 페이지 6

{카테고리_이름} Great Little Trading Paddington에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Great Little Trading Paddington 10 페이지. Bunkbed

STEP 3: It is suggested this step is completed on the floor.

Using the dowels, assemble the bed end by locating one of the prepared upper

bunk headboards (G) and headboard rails (E) into the upper section of the LH

assembled leg, then locate the lower bunk headboard (F) and headboard rail

(E) into the lower section of the LH assembled leg as shown.

Please note the IMPORTANT orientation guidance below on both

panel E's.

Once all 4 panels are in place locate the RH assembled leg into place.

Repeat this for the second bed end.

IMPORTANT: The orientation of BOTH

panel E's is important and if assembled

upside down, it will cause alignment issues

later on in the assembly.

Note the dowels on ends of panel E are

not centralised. Please ensure that the 2x

dowels are closest to the bottom edge

of the panels/rails.

STEP 4:

Secure panels G & 2x E to the assembled legs using 8x 30mm SHORTER wood screws

(#8).

Note: Hardware #9 is very similar in size (35mm), but will damage the panels if used.

Please check before using.

Repeat step with second bed end.

Hardware for Step 4:

16x #8 Screws 30mmL