Gaggenau AW 200 작동 및 조립 지침 매뉴얼 - 페이지 18

{카테고리_이름} Gaggenau AW 200에 대한 작동 및 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gaggenau AW 200 20 페이지. Extractor hood
Gaggenau AW 200에 대해서도 마찬가지입니다: 작동 및 조립 지침 매뉴얼 (13 페이지)

페이지 인쇄

Fig. 21

Fig. 22

Fig. 23

– Secure the hood on the wall with the four screws b

(Fig. 21 and 22).

For exhaust air mode proceed as follows:

– Establish the pipe connection.

– Establish the electrical connection.

– Stainless steel chimney only (AD 010-012/022):

pull the protective film off the chimney's trims.

Note: avoid damaging the sensitive metal surfaces.

– Fit the top chimney duct unit into the base. Make

sure that the fastening holes on the side are at the

top.

– Put both chimney duct units onto the hood.

– Pull the top chimney duct unit up into its final

position and secure it with 2 screws on the ceiling

holder (Fig. 23).

Note: avoid scratches when pulling the elements

apart by placing the assembly template, for

example, over the edge of the bottom chimney

paneling to protect it.

– Insert the grease filters.