DAYCO D165DC 운영자 매뉴얼 - 페이지 8

{카테고리_이름} DAYCO D165DC에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DAYCO D165DC 19 페이지.

D165 SERIES HOSE CRIMPING

Position the dies in the crimper as shown making certain that

the die rings set squarely on the pressure plate and that the die ring

halves do not overlap each other.

Align the hose and fitting in the die set and place the

Compression Ring loosely over the die set. Manually depress the

compression ring until the fitting is held loosely in the die set.

Select the proper crimp setting from the Crimp Specification

chart and set the Micro Crimp adjuster at the setting recommended.

Note: Each die set has a limited range of diameters for which a

satisfactory crimp can be obtained. As a "rule of thumb" a standard

die set can crimp 3 mm (.120 inches) above the closed diameter etched

on the die ring. Always consult the hose and fitting manufacturer's

recommendation for the correct die set to use.

Page