2gig Technologies Vario 빠른 설치 매뉴얼 - 페이지 4

{카테고리_이름} 2gig Technologies Vario에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 2gig Technologies Vario 18 페이지. Voice module
2gig Technologies Vario에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (6 페이지), 빠른 사용 설명서 (10 페이지)

페이지 인쇄

Introduction

This quick start guide introduces 2GIG alarm dealers and professional installers to the 2GIG Vario System. It describes all common 2GIG Vario System

installation and programming steps (based on factory default settings). For more detailed instructions, refer to the 2GIG Vario System Installation &

Programming Guide.

Select a Mounting Location

Decide where to position the 2GIG Vario system control panel. If possible, choose a central location in order to minimize wiring to expanders and accessories.

Before the installation, prepare map out the physical locations of all expanders and accessories. This will determine which types of expanders are required at

each location.

The control panel location should:

Be in a dry place near an AC power supply

Be accessible for routing cables to the system from detection devices

Be accessible to the customer's phone lines or IP network

Install Hardware

Main Unit—BUS Connection

The four terminals on the left side of the terminal block represent the expansion BUS. These terminal support the connection of keypads and expansion

modules. The connections are terminal-to-terminal with color-coded wires, as follows:

AUX RED: +12VDC power

COMM BLK: 0V common

BUS YEL: Yellow data

BUS GRN: Green data

Connect all keypads, expanders, and accessories necessary for the installation using the BUS connections.

2GIG Vario Quick Install Guide