- ページ 4
セキュリティシステム 2gig Technologies VarioのPDF クイック・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。2gig Technologies Vario 18 ページ。 Voice module
2gig Technologies Vario にも: 取付説明書 (6 ページ), クイック・ユーザー・マニュアル (10 ページ)
Introduction
This quick start guide introduces 2GIG alarm dealers and professional installers to the 2GIG Vario System. It describes all common 2GIG Vario System
installation and programming steps (based on factory default settings). For more detailed instructions, refer to the 2GIG Vario System Installation &
Programming Guide.
Select a Mounting Location
Decide where to position the 2GIG Vario system control panel. If possible, choose a central location in order to minimize wiring to expanders and accessories.
Before the installation, prepare map out the physical locations of all expanders and accessories. This will determine which types of expanders are required at
each location.
The control panel location should:
Be in a dry place near an AC power supply
Be accessible for routing cables to the system from detection devices
Be accessible to the customer's phone lines or IP network
Install Hardware
Main Unit—BUS Connection
The four terminals on the left side of the terminal block represent the expansion BUS. These terminal support the connection of keypads and expansion
modules. The connections are terminal-to-terminal with color-coded wires, as follows:
AUX RED: +12VDC power
COMM BLK: 0V common
BUS YEL: Yellow data
BUS GRN: Green data
Connect all keypads, expanders, and accessories necessary for the installation using the BUS connections.
4
2GIG Vario Quick Install Guide
Copyright © 2016 Nortek Security & Control LLC