Gaggenau VG 425 211 AU 사용 설명서 - 페이지 8

{카테고리_이름} Gaggenau VG 425 211 AU에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gaggenau VG 425 211 AU 16 페이지.

페이지 인쇄

Operating the appliance

Individual parts of the burners

Ensure that the individual parts of the burners are fitted

in the correct position and are straight; otherwise, this

may result in ignition problems or problems during

operation.

Fit the burner head and the burner ring in such a way

that the latches on the lower section of the burner click

into place in the corresponding slots. The alignment of

the burner head and the burner ring is not important.

Note: If the burner parts are fitted at an angle, the

appliance will not work.

Individual parts of the standard output burner and

high output burner

(

Burner cap

Burner ring

Burner head

Ignition plug

Thermocouple

Operating the appliance

N otes

O p e r a t i n g t h e a p p l i a n c e

–

Only use the accessories specified. Do not line the

stainless steel recess (e.g. with aluminium foil).

–

The burner and ignition plug must be clean and dry.

–

Only light the hotplates if the pan supports and all

burner parts are correctly fitted.

–

When one burner is ignited, an ignition spark will

also be generated at all the other burners.

–

Do not touch the ignition plug while the gas

appliance is being lit.

–

It is important to keep the appliance clean. If the

ignition plugs are dirty, this may cause ignition

problems. Clean the ignition plugs regularly with a

small, non-metallic brush. Take care to prevent the

ignition plugs from suffering any heavy knocks.

–

When you switch from setting 3 to setting 4 or

higher, the burner will briefly switch to its maximum

output. This is to optimise ignition between the

burner rings.

–

Do not cover the ventilation openings on the rear of

the gas hob.

–

When the gas cooktop is switched on, the

electronics open up the gas supply, which

produces a short sound. This is normal.

–

In the event of a power failure, the appliance will

not work. The gas supply is shut off.

Abnormal operation

Flames are usually blue and sharply defined. If the

flames are yellowish or noisy or if the gas does not

ignite within the period specified under "switching on"

abnormal operation is indicated. Refer to chapter "After-

sales service" of this manual for service contact details.