DAYLIFF AQUASTRONG SMART 45 설치 및 운영 매뉴얼 - 페이지 11

{카테고리_이름} DAYLIFF AQUASTRONG SMART 45에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DAYLIFF AQUASTRONG SMART 45 16 페이지. Water boosting pump

Full Automatic Mode: In automatic mode, set pressure and operating

pressures are shown on the display. Adjust the pump's pressure by pressing the

"+" or "-" button. Setting ranges from 1.5 to 5.5bar.

Forced Start Mode: In forced mode, motor speed is shown on the display.

Adjust the motor rotations' speed by pressing "+" or "-" button. The speed ranges

from 2,500 to 5,200 rpm.

Hold on the "+" and "-" button simultaneously for 1.5 seconds to reset the pump.

Faulty LED Indicator Guidelines

Set

Pressure

Setting

pressure

switch

1. Power supply failure

2. Pipeline leakage

3. The pump is blocked

Operating

Pressure

-SMART45

Operating

pressure

Warning Indicator

down

Lights

Switch on the power supply. Check the

cables and cable connection for defects,

loose connections or for blown fuses in the

electrical installation.

Check whether there is any leakage in the

pipeline or the tap and repair.

Check whether there is foreign matter in the

pump and clean. The pump will work

normally. The indicator light will then turn

off. If not, contact authorized D&S dealer.