GREAT PLAINS 605NT 유지 관리 매뉴얼 - 페이지 3

{카테고리_이름} GREAT PLAINS 605NT에 대한 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLAINS 605NT 7 페이지. Six foot no-till

2) After hooking the drill to the tractor and attaching hydraulic hoses, raise the drill up

to maximum height and hold the hydraulic lever in the detent for 30 seconds, to allow

the cylinders to rephase. This procedure will remove any air in the system allowing

the drill to raise and lower evenly. The rephasing procedure should be repeated

several times a day to ensure that the drill continues to lift evenly. Remove the

transport locks. This procedure will remove any air in the system allowing the drill to

plant even. After finishing each field it is best to do this procedure to keep the drill

running level in the planting position.

3) Leveling the drill.

A) Lower the 605NT drill to the ground and hold the hydraulic lever until the wheel

cylinders are completely retracted. At this point, walk to the side of drill and

visually check to see if the drill box lid and frame is parallel to the ground, if not

adjust the turnbuckle on the tongue until the drill lid or frame is level.

B) Lower the 3P605NT and pull ahead at field speed. The bench setting is 24 ¾

inches from the opener mount tube to the ground. This is a bench setting and

will change as the coulters are raised or lowered. Changing of this

measurement is normal and necessary to maintain proper coulter depth. The

drive wheel may need adjusting due to ground conditions. Check to see if the

top of the grain box is level with the ground, if not, adjust the center link on

the tractor.