73RC 73TEN 조립 설명서 - 페이지 4

{카테고리_이름} 73RC 73TEN에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 73RC 73TEN 6 페이지. 1/10th scale competition on-road chassis kit

Step 4

FH Screw 3x5mm

CH Screw 2x6mm

* Clip on side links first, then align centre pivot and tighten the 3x5mm screw. Now adjust the pivot block

to ensure the pod moves freely in all directions before tightening the two outer screws. Do not

overtighten - just snug! Finally, fit 2x6mm screws to side links - again do not overtighten, ensure they

rotate on the balls freely.

BAG 3

Step 1

Ball Stud 4.3x6mm

Lock Nut 3mm

BH Screw 3x10mm

* Please take note of Damper Brace hole placement, refer to the diagram below for an explanation. (Ball

studs and lock nuts are included in the full kit only).

73TEN 235mm Chassis