Hi-Tech Diamond 31-000 사용 설명서 - 페이지 10

{카테고리_이름} Hi-Tech Diamond 31-000에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Hi-Tech Diamond 31-000 16 페이지. 10" slab saw

페이지 인쇄

1. Machine Details

ARBOR & MOTOR SHAFT

Oiling (or greasing) the inside of the stainless

steel arbor and the motor shaft is required

because the arbor and motor shaft are made of

different materials. Over time, they can seize to-

gether, making it impossible to remove the arbor

from the shaft. Every two months or so, remove

the arbor from the motor shaft by loosening the

two set screws using the included Allen wrench,

turning counter-clockwise. Once loosened, slide

the arbor off the motor shaft. Apply a few drops of

motor oil, way oil, lithium or water pump grease

inside the arbor where it fits onto the shaft. Also

apply a few drops of oil or grease onto the motor

shaft, rubbing to coat the shaft lightly. Make sure

there is no excess oil so that oil doesn't drip down

the motor shaft and get into the motor. This will

cause an instant motor burn-out. Replace the

arbor onto the shaft, using the Allen wrench to

tighten the two set screws.

Motor shaft with grease

MAINTENANCE

Arbor

ARBOR & BRASS BAR

Greasing the inside of the brass bar where the

arbor fits into is required because the arbor and

brass bar are made of different materials. Over

time, they can seize together, making it impos-

sible to separate from each other. Insert lithium

grease or marine grease inside the brass bar

(Fig. E) every time you change the saw blade. We

suggest greasing this part more frequently than

when you oil (or grease) the arbor and motor shaft

because these parts create more friction. Note:

Only use lithium grease or marine grease. Using

different oils may cause the arbor to lock-up into

the brass bar, making it impossible to remove.

Insert grease

here

CLEANING

After each use, drain the water reservoir by re-

moving the drain plug. Any used water must not

be disposed down a sink, as rock sediment can

harden like cement, closing off the drain. Dry the

machine and saw blade with paper towels or a

cloth. You may also spin dry the saw blade by run-

ning it on the trim saw until it is completely dry.

Notes: Always dry your saw blade after each use to

prevent rusting. Keep out of reach of children.

MOTOR DETAILS

For questions regarding the motor, please refer to

the instructions provided by the motor manufac-

turer (included with this instruction manual).

Fig. E