Hi-Tech Diamond 31-000 사용 설명서 - 페이지 11

{카테고리_이름} Hi-Tech Diamond 31-000에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Hi-Tech Diamond 31-000 16 페이지. 10" slab saw

SAW BLADE ADJUSTMENTS

BLADE POSITIONING &

CLEARANCE ADJUSTMENTS

Follow these four steps to adjust the position of

the saw arbor and saw blade so that the blade

does not make contact with the saw table. This

process may require trial and error.

Remove the saw table, then remove the brass

bar. Loosen the two set screws located in

the saw arbor using the Allen wrench, turning

counter-clockwise (Fig. F). Once loosened, the

saw arbor can slide side to side.

Replace the saw table and position the saw

blade so that it is not in contact with the saw

table. Your blade should spin freely.

Remove the saw table to tighten the two

set screws using the Allen wrench, turning

clockwise, and replace the brass bar.

Replace the saw table and manually rotate

the saw blade, making sure the blade is not

making contact with the saw table one last time

before turning the slab saw on.

NEED A REPLACEMENT SET SCREW?

The two set screws located in the saw arbor are available at your local hardware store. The size of the

set screws are 18-8 stainless steel, cup point, 10-32 thread, 3/16" long.

Fig. F