75F Smart Damper 설치 및 작동 지침
{카테고리_이름} 75F Smart Damper에 대한 설치 및 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. 75F Smart Damper 3 페이지.
페이지 인쇄
|
APPLICATION
The 75F® Smart Damper™ is to be used as part of the 75F®
Dynamic Airflow Balancing™ solution. The Smart Damper will be
paired with a 75F® Smart Node™ which will provide power and
control.
|
PRECAUTIONS
•
Be sure Smart Node is accessible for wiring.
•
When installing multiple dampers in a zone, only provide the
24VAC power bus line to one of the two Dampers. The Smart
Node will be attached to the primary damper.
•
Failure to wire devices with the correct polarity when using a
shared transformer may result in damage to any device
powered by the shared transformer.
•
Disconnect power before installing. Never connect or
disconnect wiring with the power applied.
•
Do not run the low voltage wiring in any conduit with line
voltage.
•
Install in accordance with all State and local codes.
|
FEATURES
•
Modulation of airflow through the duct controlled by the 75F
Dynamic Airflow Balancing™ solution.
•
Monitors airflow temperature.
|
SPECIFICATIONS
Smart Damper
•
Supply Voltage: 24VAC
•
Operating Environment: 41°F – 122°F
•
Dimensions: (H) 6"; Diameter 6, 8, 10, 12", or custom sizes
•
Enclosure: Metal sheath
INSTALLATION & OPERATION INSTRUCTIONS
75F® Smart Damper™ | RADIAL
www.75f.io
888.590.8995 x2