ADEMCO Accord 사용자 지침 - 페이지 6
{카테고리_이름} ADEMCO Accord에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. ADEMCO Accord 10 페이지.
페이지 인쇄
- 1. Table of Contents
- 2. Full Set [1]
- 3. Part Set [2]
- 4. Night Set [3]
- 5. Unsetting
- 6. Unsetting after or During an Alarm
- 7. Testing the System [5]
- 8. Reprogramming Codes [8]
- 9. Isolating Zones [6]
- 10. Chime Facility [9]
- 11. Viewing the Alarm Log [0]
- 12. Indicators and What They Mean
- 13. System Settings
- 14. System Limitations
displayed first, indicated by the zone LED and
a beep.
INDICATIONS AND WHAT THEY
INDICATIONS AND WHAT THEY
MEAN
MEAN
POWER – There is one power LED at the
control unit and one on each keypad. If the
Power LEDs are on then there are no
problems with the a.c. mains supply, if the
Power LEDs are off this indicates an a.c.
mains failure.
An a.c. mains failure may be accompanied by
an audible warning (if programmed). This can
be silenced by entering a valid code.
If the Power LEDs are flashing contact your
Alarm Company. Do not press any keys.
TAMPER – If the Tampers LED on the
keypad(s) is on one of the system devices has
been tampered with. Contact your Alarm
Company for advise.
DAY LEDs
'On' – This indicates that the sytem is unset.
'Flashing' – This indicates that the system is
setting.
The LED will extinguish when the
system has successfully set.
ZONE LEDs
'On' – This indicates that the zone has
caused an alarm or the zone is not clear
during the setting procedure.
If you are in the Test mode it indicates that the
zone has been successfully tested.
'Flashing' – This means that the zone has
been Isolated.
'Off' – This is the normal condition for zone
LEDs.
6