Hi-Z Antennas 4-8 PRO 매뉴얼 - 페이지 7

{카테고리_이름} Hi-Z Antennas 4-8 PRO에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Hi-Z Antennas 4-8 PRO 15 페이지. Up 8 element circle array

Fig.1

Fig.2

Connect the Control Cable – Ctrl 3 as shown in Fig.1.

Connect one of each 2 foot jumper wires with terminals to the Ground and 13.8VDC terminals, see Fig. 3. The other end on

these wires will terminate to the same labeled terminals on the Hi-Z 4-8PRO phase controller, see Fig.4.

Fig. 3

Fig. 4

Both controllers will be supplied with a RED jumper connected between the 13.8 VDC and Coax Power In terminals. This

supplies the voltage to the Hi-Z amps over the coax. Do not remove this jumper.

Connecting the Verticals and Delay Cable to the Phase Controller

Hi-Z 4-8PRO UP Manual V1.0