Hi-Z Antennas 4-8 PRO 매뉴얼 - 페이지 8

{카테고리_이름} Hi-Z Antennas 4-8 PRO에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Hi-Z Antennas 4-8 PRO 15 페이지. Up 8 element circle array

Fig. 5

1. Run equal lengths of RG6 from the Hi-Z 4-8PRO PnP controller to each vertical. This connects to the Hi-Z 4-8PRO PnP

controller Ant 1-8 to verticals 1-8. Be certain to observe these connections based on the orientation or placement of

verticals for correct aiming. Fig. 5 & Fig.6 These cables MUST be the same length as currently installed with the Hi-Z 4.

2. Connect the Hi-Z supplied short and long Delay cables at Short Delay and Long Delay connectors on the Hi-Z 4-8PRO

phase controller. Fig.7

Connect the factory supplied 2 foot wire jumper with fork terminals from either of the 13.8VDC terminals on the controllers

and connect the other end to the 13.8VDC terminal on the75Ω In-line pre-amp.

Connect the factory supplied 2 foot RG6 cable from the OUTPUT of the Hi-Z 4-8 phase controller (Fig.4) to the input connector

on the in-line pre-amp. See Fig. 8

Connect the 13.8VDC and GND from the phase controller to the PnP controller (2ft long wires, supplied with system).

Hi-Z 4-8PRO UP Manual V1.0

Fig. 7

Fig.6