DYNACO SCA-80 조립 설명서 - 페이지 8

{카테고리_이름} DYNACO SCA-80에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DYNACO SCA-80 15 페이지. C9 replacement
DYNACO SCA-80에 대해서도 마찬가지입니다: 매뉴얼 (12 페이지)

페이지 인쇄
DYNACO SCA-80 조립 설명서

Install the 24 Volt Regulator, TO-220 Package

The 24 volt regulator (P/N TL783), U1, comes in a TO-220 package that looks like this
(there may be some variation in the plastic molding):
1
Install it with a heat sink, 6-32x3/8" screw
, and a keps nut following Figure 4. The
captive lock washer side should face the solder side of the PCB. Bend the leads down to
fit through the three holes in the PCB. Adjust everything so that it fits well. Tighten the
hardware, then solder the 3 leads.

Figure 4-Front and Back views of Q6 mounted on heat sink

1
This is the longest screw in the kit, as the other four screws are 6-32x1/4".
Page 8 of 15