DYNACO SCA-80 조립 설명서 - 페이지 9
{카테고리_이름} DYNACO SCA-80에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DYNACO SCA-80 15 페이지. C9 replacement
DYNACO SCA-80에 대해서도 마찬가지입니다: 매뉴얼 (12 페이지)
페이지 인쇄
Install the Capacitors
Install the polarized electrolytic capacitors. Note that + sign on the silk-screen shows
where the positive side of the capacitor should go. However, the markings on the caps
prominently show the negative side. Make sure that the non-negative side of the cap
connects to the hole indicated by the positive sign on the silk screen.
Designation
Value
C1
22 µF, 63 V
C2
22 µF, 63 V
C3
470 µF, 100
V
C4
470 µF, 100
V
Solder GJ1 in Place
Insert a piece of 20 AWG wire from the component side of the board into the two holes
adjacent to GJ1 on the silk screen. Solder both ends of the wire on the solder side of the
PCB.
Remove the Old Power Supply
1. Disconnect the SCA-80 from your music system.
2. Unplug the power cord and allow the amp to sit for one minute before moving on.
Caution: Be sure that the power is unplugged! 120/240 VAC can be lethal!
3. Remove the 5 screws that hold the cover in place, 2 on the left side, 2 on the right
side, and one in the back.
4. Lift the cover straight up and set it aside in a safe place.
Marking
22 µF, 63 V, and minus sign for polarity
22 µF, 63 V, and minus sign for polarity
470 µF, 100 V, and minus sign for
polarity
470 µF, 100 V, and minus sign for
polarity
Figure 5-Remove these wires from C11
Page 9 of 15
Done? ()