ADEMCO LYNX 시스템 매뉴얼 - 페이지 7

{카테고리_이름} ADEMCO LYNX에 대한 시스템 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ADEMCO LYNX 14 페이지.
ADEMCO LYNX에 대해서도 마찬가지입니다: 사용자 설명서 (17 페이지), 빠른 시작 매뉴얼 (8 페이지)

Ademco Lynx System Manual

should also be lit.

4. Enter your [user code] and then press [TEST].

5. The external sounder should sound for 2 seconds and then turn off.

FAULT ZONES. Open each protected door and window in turn and listen for three beeps from the

keypad. Identification of each faulted protection point should appear on the display. The display will clear

when the door or window is closed.

Walk in front of any interior motion detectors (if used) and listen for three beeps. The identification of the

detector should appear on the display when it is activated, and its voice descriptor will be announced (if

programmed). The display will clear when no motion is detected. Note that if wireless motion detectors

are used, there is a 3-minute delay between activations. This is to conserve battery life.

To test all smoke detectors, follow the manufacturer's instructions. The identification of each detector

should appear on the display when each is activated.

If a problem is experienced with any protection point (no confirming sounds, no display), notify your

service company.

When all protection points have been checked and are intact (closed), there should be no zone

identification numbers displayed on the keypad

Exit Test Mode

When testing is completed, exit the Test Mode by entering your [security code] and pressing the [OFF]

key.

If the Test Mode is inadvertently left active, it will automatically turn off after 4 hours.

To learn more about testing your system, please visit

Other System Information

For a more detailed description of these features, please refer to the manufacturer's complete manual.

Time & Date Programming

Your system can display the current time. The date is not displayed, but has an internal function. The

system must be disarmed with no faults present.

To set the time and date, enter the [Master code] and press [FUNCTION] and enter [63].

NOTES:

http://alpha.adt.com/help/261[11/14/2018 8:02:22 PM]

System

Testing.