DynaColor 900 series Hybrid 설정 매뉴얼 - 페이지 5

{카테고리_이름} DynaColor 900 series Hybrid에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DynaColor 900 series Hybrid 11 페이지. Lite h.264 dvr

Dome Camera Control

Dome Camera Connection & Settings:

• See section Pin Definition of Alarm I/O & RS-485, and Audio In for RS-485 port pin definition.

• Refer to the following figure. Connect the R+, R- terminals on the dome camera to the D+, D-

terminals on the RS-485 port by RS-485 cable respectively.

• To set up dome camera's protocol and ID, press MENU to access the OSD main menu, and

select <Camera Setup>. Then select <Dome Protocol> and choose the corresponding

protocol. Next select <Dome ID> and choose a preferred ID number. Note that the ID number

must match the ID address defined by the dome camera.

• To configure the RS-485 parameters, select <System Setup> from OSD main menu, and then

select <RS485 Setup>. The default RS-485 settings are 9600 Baud, 8 Data Bits, 1 Stop Bit and

No Parity.

Control Buttons in Dome Camera Control Mode:

Set / Go Preset

Go Presets 1~6

Enter Dome Camera

Control Mode

Iris Close

Focus Near

Zoom In

Pan / Tilt

Iris Open

Focus Far

Zoom Out

ESC

Enter / Auto