DynaColor 900 series Hybrid Руководство по настройке - Страница 5

Просмотреть онлайн или скачать pdf Руководство по настройке для DVR DynaColor 900 series Hybrid. DynaColor 900 series Hybrid 11 страниц. Lite h.264 dvr

Печатать страницу

Dome Camera Control

Dome Camera Connection & Settings:
• See section Pin Definition of Alarm I/O & RS-485, and Audio In for RS-485 port pin definition.
• Refer to the following figure. Connect the R+, R- terminals on the dome camera to the D+, D-
terminals on the RS-485 port by RS-485 cable respectively.
• To set up dome camera's protocol and ID, press MENU to access the OSD main menu, and
select <Camera Setup>. Then select <Dome Protocol> and choose the corresponding
protocol. Next select <Dome ID> and choose a preferred ID number. Note that the ID number
must match the ID address defined by the dome camera.
• To configure the RS-485 parameters, select <System Setup> from OSD main menu, and then
select <RS485 Setup>. The default RS-485 settings are 9600 Baud, 8 Data Bits, 1 Stop Bit and
No Parity.
Control Buttons in Dome Camera Control Mode:
Set / Go Preset
1
Go Presets 1~6
2
Enter Dome Camera
3
Control Mode
Iris Close
4
Focus Near
5
Zoom In
6
Pan / Tilt
7
Iris Open
8
Focus Far
9
Zoom Out
10
ESC
11
Enter / Auto
12
5