GREAT PLANES COMBAT MUSTANG Combat P-51 ARF 사용 설명서 - 페이지 8

{카테고리_이름} GREAT PLANES COMBAT MUSTANG Combat P-51 ARF에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLANES COMBAT MUSTANG Combat P-51 ARF 20 페이지.

8. Position the plywood aileron servo tray over the servo

location in the center-section of the wing. Trace the outline

of the tray onto the wing with a fine-tipped marker. Carefully

cut the covering from the wing inside the lines you have

made on the wing. Be sure to only cut through the covering

and not the wood.

9. Glue the plywood aileron servo tray to the wing with

6-minute epoxy.

Install the Aileron Servo & Pushrods

1. Insert the aileron servo into the aileron servo tray.

Using the servo as your guide, drill a 1/16" [1.6mm] hole

through the servo tray for each of the mounting holes.

Remove the servo from the tray. Insert and then remove a

servo mounting screw (included with your servo) from each

of the holes you have drilled. Apply a couple of drops of thin

CA into the holes to harden the threads. When the CA has

cured, install the servo into the servo tray using the

hardware provided with your servo.

2. Locate a 2 x 114mm pushrod wire threaded on one

end. Screw a nylon clevis and a silicone clevis retainer

onto the threaded end of the wire 20 full turns. Install the

clevis onto one of the aileron torque rod connectors.

Center the servo arm and center the aileron. Mark the

location where the wire aligns with the hole in the servo arm.

Bend the wire 90 degrees on this mark and then cut the

excess wire 3/8" [9.5mm] above the bend.

3. Be sure the aileron servo is centered. Enlarge the

second hole in the servo arm with a Hobbico Servo Horn

Drill (or a #50 or 5/64" [2mm] drill bit). Attach the clevis to

the aileron torque rod connector, slide the silicone clevis

retainer over the clevis and install the wire into the servo

arm and retain it with a nylon FasLink. Do this for both the

left and right aileron.