Aircraft in Miniature Limited TRANSPORT WINGS DC-10-30 KIT 사용 설명서 - 페이지 10
{카테고리_이름} Aircraft in Miniature Limited TRANSPORT WINGS DC-10-30 KIT에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aircraft in Miniature Limited TRANSPORT WINGS DC-10-30 KIT 20 페이지. 1:72 mixed-media kit of the dc-10-30 second generation jet airliner
페이지 인쇄
(12) Fuselage assembly.
(a) Attach these sub-assemblies to one fuselage half:
(b) When the keel is securely bonded to the fuselage half, file
(c) Attach nose weights to the nose gear bay top surface
(d) Put the tailplane in place in the two fuselage halves.
(e) Clip the other fuselage half on to the keel, cement it with
(f)
4
WING SUB-ASSEMBLY
NOTES
A
Sand the wing parts to their correct shape and make sure they fit
together correctly.
B
Prepare a wooden spar for each wing. Assemble the top and bottom
of the wings with the spars in place, WITHOUT ANY CEMENT to
make sure that they fit correctly.
WING SPAR
WING ATTACHMENT
BLOCK
LEFT WING
- LOWER HALF
- NLG bay
- CLG bay
- Centre engine intake duct
- Centre engine assembly
- Keel (put the keel into the fuselage to half its depth and
flood the joint with liquid cement).
the mating face of the keel to suit the curvature of the other
fuselage half.
(approximately 40 g).
liquid polystyrene cement and hold the two halves together
with adhesive tape until the fuselage is dry.
Fill and sand the joints in the fuselage assembly.
1 - We recommend that you put a wooden spar (not
provided in the kit) in each wing to prevent the
wings drooping with age.
2 - When the wings are assembled, cut off each wing
tip and attach the resin wingtips supplied.
LEFT WING
- UPPER HALF
EXPLODED VIEW OF LEFT WING
(RIGHT WING IS MIRROR IMAGE)