Aircraft in Miniature Limited TRANSPORT WINGS DC-10-30 KIT 사용 설명서 - 페이지 11
{카테고리_이름} Aircraft in Miniature Limited TRANSPORT WINGS DC-10-30 KIT에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aircraft in Miniature Limited TRANSPORT WINGS DC-10-30 KIT 20 페이지. 1:72 mixed-media kit of the dc-10-30 second generation jet airliner
페이지 인쇄
C
Cut out the main landing gear doors in the wing lower surface.
D
Make two sets of main landing gear bay parts. Cut out these parts
from the .080"/2 mm plastic sheet supplied:
E
Cement the wing spars in place, before cementing the wing halves
together.
F
Cut off and discard each wing tip and attach the resin wingtips as
shown below (left side shown, right side similar).
G
Fill and sand the joints in the wing assemblies
5
WING ENGINE SUB-ASSEMBLIES
A
Remove all the flash and feeds from the resin engine parts and
pylons.
B
Assemble the two engines. The bullet on the cast metal fan discs can
be polished if required, before they are glued into the intakes of the
engines.
C
Attach the intake fences.
-
Packers to let the
-
Panels to fill the space between the upper and lower
faces of the wing, to give the fore and aft faces of the
main landing gear bay structure.
T-brackets sit horizontally