Aircraft in Miniature Limited TRANSPORT WINGS DC-10-30 KIT 사용 설명서 - 페이지 7
{카테고리_이름} Aircraft in Miniature Limited TRANSPORT WINGS DC-10-30 KIT에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aircraft in Miniature Limited TRANSPORT WINGS DC-10-30 KIT 20 페이지. 1:72 mixed-media kit of the dc-10-30 second generation jet airliner
페이지 인쇄
(4) Make the NLG and CLG bay parts.
(a) For the NLG cut out these parts from the .080"/2 mm plastic
sheet supplied:
-
Roof panel - 50 mm x 22 mm
-
Two side panels, each 50 mm x 20 mm
-
Front and rear bulkheads to the shape shown below.
22
(b) For the CLG cut out these parts from the .080"/2 mm plastic
sheet supplied:
-
Roof panel - 50 mm x 22 mm
-
Two side panels, each 50 mm x 20 mm
-
Front and rear bulkheads to the shapes shown below.
18
(5) Cut off the centre engine intake. Also use the resin bypass duct
halves as templates cut away the rear fuselage until the resin
parts fit well as shown in the sketch below.
(6) Put half the thickness of the keel into one fuselage half and
cement it in place with liquid polystyrene cement.
(7)
File the edge of the fuselage keel to the internal radius of the
opposite fuselage half.
All dimensions in millimeters.
Skech not to scale.
Profile to suit fuselage curvature.
All dimensions in millimeters.
Skech not to scale.
Profile to suit fuselage curvature.