GREAT PLANES Fokker D.VII ARF ElectriFly 사용 설명서 - 페이지 10

{카테고리_이름} GREAT PLANES Fokker D.VII ARF ElectriFly에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLANES Fokker D.VII ARF ElectriFly 20 페이지.

❏

4. Attach the RimFire motor to the back of the plywood

motor mount with three 3mm x 6mm [1/8" x 15/64"] machine

screws. Apply a drop of threadlocker on the threads of the

machine screws. Insert each of three 3mm x 30mm [1/8" x 1-3/16"]

machine screws through a 3mm [1/8"] washer, the outer holes

of the motor mount, another 3mm [1/8"] washer, a 17mm

[21/32"] tube, and another 3mm [1/8"] washer as shown in the

drawing. Apply a drop of threadlocker on the threads of each

screw and install the motor mount to the firewall.

❏

5. Install a 3.5mm [9/64"] Bullet (male) to 2mm [5/64"]

Bullet (female) connector adapter (GPMM3122) on each of

the motor leads. Connect the motor leads to the ESC. Push

the wires up into the fuselage to prevent them from

contacting the rotating motor case.

Install the Linkages

❏

1. Use a sharp hobby knife to trim the covering from over

the small rectangular holes towards the LE of the rudder and

the bottom of the elevator as shown. Do not cut all the way

through the rudder or elevator.

❏

2. Test fit the control horns in the holes so that they are

perpendicular to the control surface. Once satisfied with the

fit, use CA to secure the control horns in place.

❏

3. Insert the two 460mm [18"] wire pushrods into the

outer pushrod tubes at the rear of the fuselage as shown.