GREAT PLANES Fokker D.VII ARF ElectriFly 사용 설명서 - 페이지 6

{카테고리_이름} GREAT PLANES Fokker D.VII ARF ElectriFly에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLANES Fokker D.VII ARF ElectriFly 20 페이지.

PREPARATIONS

❏

1. If you have not done so already, remove the major

parts of the kit from the box (wing, fuselage, tail parts, etc.)

and inspect them for damage. If any parts are damaged or

missing, contact Product Support at the address or

telephone number on page 5.

❏

2. Separate the ailerons from the wing, the rudder from

the fin and the elevator from the stabilizer. If necessary, use

a covering iron set on medium/high to carefully tighten the

covering. Lay the control surface on a flat surface and apply

pressure over sheeted areas to thoroughly bond the

covering to the wood. Hint: Poke three or four pin holes in

the covering over the open structure in the tail surfaces. This

will allow the hot air to escape while tightening the covering.

WARNING: DO NOT OVER SHRINK THE COVERING OR

IT WILL CAUSE THE CONTROL SURFACES TO TWIST.

❏

3. Check the hinge slots of all control surfaces using a

hobby knife with a #11 blade. This will help when installing

the hinges.

❏ ❏

1. Test fit the right aileron to the top wing with two

6.4mm x 15mm [1/4" x 5/8"] hinges. If the hinges don't stay

centered, stick a pin through the middle of the hinges to hold

them in position while fitting the aileron to the wing.

❏ ❏

2. Remove any pins you may have inserted into the

hinges. Install the aileron so there is a very small gap

between the LE of the aileron and the wing. The gap should

be small – just enough to see light through or to slip a piece

of paper through.

❏ ❏

3. Apply three drops of thin CA to the top and bottom

of each hinge. Do not use CA accelerator. After the CA has

cured, test the hinges by pulling on the ailerons.

❏

4. Repeat steps 1-3 for the left aileron.