ActiveAid 600 소유자 매뉴얼 - 페이지 16

{카테고리_이름} ActiveAid 600에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ActiveAid 600 19 페이지.

Usage

Seat

Remove by lifting one corner at a time or lift off one side only and pivot the seat up from the opposite side.

Back

Loosen then remove the self-locking nut and screw that are securing the back assembly to the frame. Pull up on

the back assembly. Re-insert the screw through the holes in the chair frame. Hand start the nut onto the end of

the screw.

Adjustable Sling Back

Loosen strap thru buckle to decrease tension, tighten strap thru buckle to increase tension.

Leg Rests

Adjust the height of the foot plate by depressing snap button and sliding foot plate mount up or down to obtain

correct height. Remove leg rest assembly by lifting up on the gooseneck to remove it from the receiver of the

front support.

Elevating Leg Rest

Adjust the height of the leg rest by depressing snap button and sliding foot plate mount up or down to obtain

correct height. Adjust the angle of the leg rest upward by lifting, lower by depressing the tab.

Arm Rests

Height-Adjustable Arm Rests

To raise the arm, push up on the armlock cap and pivot back the entire armrest. To lower the arm, pull down on

the front of the armrest until the arm latch locks onto the securing stud under the arm pivot.

Flip-Up Arm Rests

To raise the arm up, pivot the arm lock lever away from the armrest and armrest lock. Lift up on the armrest.

Remove by depressing the snap button and sliding it out of the armrest pivot.

Arm-Mounted Hip Guides

To adjust forward/rear position, slightly loosen front/rear knob and slide assembly forward/backward to desired

position, tighten knobs.

To adjust width, slightly loosen middle two knobs, push/pull assembly in/out to desired position, tighten knobs.

Repeat for second side.