ActiveAid 600 Panduan Pemilik - Halaman 16
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Peralatan Medis ActiveAid 600. ActiveAid 600 19 halaman.
Usage
Seat
Remove by lifting one corner at a time or lift off one side only and pivot the seat up from the opposite side.
Back
Loosen then remove the self-locking nut and screw that are securing the back assembly to the frame. Pull up on
the back assembly. Re-insert the screw through the holes in the chair frame. Hand start the nut onto the end of
the screw.
Adjustable Sling Back
Loosen strap thru buckle to decrease tension, tighten strap thru buckle to increase tension.
Leg Rests
Adjust the height of the foot plate by depressing snap button and sliding foot plate mount up or down to obtain
correct height. Remove leg rest assembly by lifting up on the gooseneck to remove it from the receiver of the
front support.
Elevating Leg Rest
Adjust the height of the leg rest by depressing snap button and sliding foot plate mount up or down to obtain
correct height. Adjust the angle of the leg rest upward by lifting, lower by depressing the tab.
Arm Rests
Height-Adjustable Arm Rests
To raise the arm, push up on the armlock cap and pivot back the entire armrest. To lower the arm, pull down on
the front of the armrest until the arm latch locks onto the securing stud under the arm pivot.
Flip-Up Arm Rests
To raise the arm up, pivot the arm lock lever away from the armrest and armrest lock. Lift up on the armrest.
Remove by depressing the snap button and sliding it out of the armrest pivot.
Arm-Mounted Hip Guides
To adjust forward/rear position, slightly loosen front/rear knob and slide assembly forward/backward to desired
position, tighten knobs.
To adjust width, slightly loosen middle two knobs, push/pull assembly in/out to desired position, tighten knobs.
Repeat for second side.
13