GREAT PLANES Micro Whizz 사용 설명서 - 페이지 8

{카테고리_이름} GREAT PLANES Micro Whizz에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLANES Micro Whizz 16 페이지.

13. Apply CA to the areas where you removed the covering

and into the slot in the stabilizer. Slide the fin/rudder into

position and place a 90° tool onto the top of the stabilizer

holding the fin in place until the glue sets as shown in the

above photograph.

14. Test fit the tail boom into the hole on the wing trailing

edge. Place the assembly onto a flat surface and move the

assembled tail section forward and aft until the

measurement from the hinge line of the elevators to the

hinge line of the ailerons is 11-1/2" [292mm]. Measure the

distance from both sides of the horizontal stabilizer to the table

surface. Adjust the tail boom until these measurements are

equal. Carefully mark the location of the tail boom in the wing.

15. When satisfied with the fit and position of the tail

assembly, remove it and apply CA inside the hole. Then

return the tail assembly to the correct position. Make sure

that the position is right before the CA has cured.

Assembly of the Fuselage/Wing

1. As shown in the photograph above, install the two

control horns in the ailerons by cutting a small portion of the

aileron away with a sharp hobby knife. Use sandpaper to

rough up the areas where the control horns will be glued.

Make sure the holes line up with the hinge line. When you

are satisfied with the position, glue it into place with CA.

2. To install the landing gear, first fit the wheels onto the

axle portion of the gear. Slip the wheel collars onto the axle.

Insert the Phillips head screws into the wheel collar and

tighten them securely. Use the photograph above as a guide.

3. Place the airplane on your work surface upside-down.

Using a sharp hobby knife, remove the covering over the

opening in the wood where the gear is placed. As shown in

the photograph above, place the landing gear into the slot in

the bottom of the fuselage.