GREAT PLANES Piper j-3 cub 사용 설명서 - 페이지 10

{카테고리_이름} GREAT PLANES Piper j-3 cub에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLANES Piper j-3 cub 16 페이지. Electrifly series
GREAT PLANES Piper j-3 cub에 대해서도 마찬가지입니다: 사용 설명서 (6 페이지)

페이지 인쇄

❏

4. Hook the remaining two 2-1/4" [57mm] pushrods into

the outer hole of the elevator and rudder control horns.

Connect the 16-1/4" [413mm] pushrods onto the inner hole

of the elevator and rudder servo horns. Slide a pushrod

support onto the elevator and rudder pushrods. Join the

pushrod wires together with a 1" [25mm] piece of heat-

shrink tubing while centering the control surfaces. Apply a

drop of CA to the ends of the heat-shrink tubing after

shrinking the tubing with a soldering iron.

❏

5. Position the pushrod supports in the middle of the

pushrods and lightly press them into the fuselage creating

indentations in the foam. Use a sharp hobby knife to cut a

hole in the foam at the indentations you made. Insert the

pushrod supports into the holes and glue them in place.

Install the Electronics & Propeller

❏

1. Determine the location of the receiver. Wipe the area with

denatured alcohol only once or twice. Excessive wiping will

remove the paint. Cut a piece of double-sided tape to fit your

receiver and stick it to the underside. Connect the aileron,

rudder, and elevator servos to the receiver. Peel the backing

from the double-sided tape and secure the receiver to the

fuselage in the location shown in the picture. For a tidy

installation you may wish to tape the servo leads to the fuselage.

❏

2. Tape the receiver antenna to the bottom of the fuselage

longeron as shown. Be sure that none of the antenna is

exposed on the underside of the airplane, as it could

become damaged on landing.

❏

3. Connect the motor leads from the ESC to the leads

coming from the motor. Plug the ESC into the receiver. Wipe

the area where the ESC will be installed with alcohol as

described in step 1. Secure the ESC to the fuselage with

double-sided tape.

❏

4. Wipe the area where the hook and loop material will be

installed as shown with alcohol as described in step 1. Apply

the "hook" side of the hook and loop material to the fuse.

❏

5. The "loop" side of the hook and loop material should be

applied to your battery.

❏

6. Attach the prop saver by tightening the two screws

against the flat spots on the prop shaft.