GREAT PLANES Piper j-3 cub 사용 설명서 - 페이지 11

{카테고리_이름} GREAT PLANES Piper j-3 cub에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLANES Piper j-3 cub 16 페이지. Electrifly series
GREAT PLANES Piper j-3 cub에 대해서도 마찬가지입니다: 사용 설명서 (6 페이지)

페이지 인쇄

❏

7. Loop the prop saver O-ring around one of the screws

and over the prop hub. Hook the O-ring onto the other screw

to secure the propeller to the prop saver. Long nose pliers

may make it easier to stretch the O-ring onto the screws.

Assemble the Landing Gear

Note: The landing gear is designed for display purposes, not

for use in flight. For this reason assembling the landing

gear is optional.

❏

1. Install the wheels onto the axle and hold them in place

with the black plastic wheel retainers.

❏

2. Slide the landing gear onto the fuselage. Hold it in

place by sliding a T-pin through the bottom of the landing

gear and into the fuselage.

GET THE MODEL READY TO FLY

Check the Control Directions

❏

1. Turn on the transmitter and receiver and center the trims.

❏

2. With the transmitter and receiver still on, check all the

control surfaces to see if they are centered. If the lengths of

the pushrods need to be adjusted to center the control

surfaces, break the glue bond at the ends of the heat-shrink

tubing and make your adjustments. Be sure to re-glue the

ends of the heat-shrink tubing to the pushrod wires when

you are satisfied.

❏

3. Make certain that the control surfaces and the throttle

respond in the correct direction as shown in the diagram. If

any of the controls respond in the wrong direction, use the

servo reversing in the transmitter to reverse the servos

connected to those controls. Be certain the control surfaces

have remained centered.

Set the Control Throws

Use a ruler to accurately measure and set the control throw

of each control surface as indicated in the chart that follows.

If your radio does not have dual rates, we recommend

setting the throws at the low rate setting.

Note: The throws are measured at the widest part of the

elevators, rudder and ailerons.

These are the recommended control surface throws:

High Rate

ELEVATOR:

1-1/4" [32mm] up

1-1/4" [32mm] down 1" [25mm] down

RUDDER:

1-1/4" [32mm] right 1" [25mm] right

1-1/4" [32mm] left

AILERONS:

(Only One Rate)

Low Rate

1" [25mm] up

1" [25mm] left

1/2" [13mm] up

3/16" [4.8mm] down