ActiveAqua AAPW160 사용 설명서
{카테고리_이름} ActiveAqua AAPW160에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ActiveAqua AAPW160 4 페이지. Submersible pump
페이지 인쇄TROUBLESHOOTING GUIDE
SYMPTOM
CAUSE
The pump does not run
Power is not turned on
Incorrectly plugged in
Bound impeller
The motor repeats ON/OFF
Wrong voltage
without running pump. It stops
The water intake or outlet pipe
and does not restart
is clogged with foreign matter
The pump runs with reduced or
Wrong frequency
no performance
Impeller worn out
Low water level
The pump runs normally at the
Hose is too long or clogged
beginning but the water flows
Air in the impeller chamber
sluggishly or there is no water
LIMITED WARRANTY
Your Active Aqua Pump is guaranteed to work for one year from the
date of retail purchase. Replaceable filter material not included. Save
your retail receipt/invoice, a copy is required for all warranty work.
Any alterations to a pump or cord will void warranty. Contact the place
of purchase for repair or replacement. Active Aqua Pumps are sold and
serviced only through dealers.
AASubPump_Instr.11
SOLUTION
Turn on the power
Plug in correctly
Remove foreign matter from impeller
Correct voltage
Clean out the intake and outlet
Correct frequency
Replace impeller
Ensure the pump is fully submerged
Shorten hose and/or clean out
To get rid of air, put pump into the
water. Turn the switch to "ON" and "OFF"
intermittently to clear air from pump
INSTRUCTION MANUAL
ACTIVE AQUA
SUBMERSIBLE PUMP
FOR MODELS: AAPW40, AAPW160, AAPW250,
AAPW400, AAPW550, AAPW800, AAPW1000
Active Aqua Pumps
from Hydrofarm are carefully inspected and
tested to ensure both safety and operating performance. However,
failure to follow the instructions and warnings in this manual may
result in pump damage and/or serious injury. Be sure to read and
save this manual for future reference.
AAPW800/550
AAPW160
AAPW1000
AAPW250/400
AAPW40