ActiveAqua AAPW160 사용 설명서 - 페이지 3

{카테고리_이름} ActiveAqua AAPW160에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ActiveAqua AAPW160 4 페이지. Submersible pump

페이지 인쇄

AAPW160

Flow control lever

Impeller

Front

cover

Intake O ring

Intake screen

foam

AAPW40

Front

cover

Impeller

cover

Tube

fittings

Outlet O ring

Impeller

Motor

Suction cups

Water outlet

Back cover

Motor

Suction cups

MAINTENANCE

To clean the pump, remove the front cover and the impeller. Use a small brush and stream

of water to remove any debris.

IF THE PUMP FAILS TO OPERATE, CHECK THE FOLLOWING:

• Check the circuit breaker and try another outlet to ensure the pump is getting

electrical power. NOTE: Always disconnect from electrical outlet before handling

the pump.

• Check the pump discharge and tubing for kinks and obstructions. Algae buildup

can be flushed out with a garden hose.

• Check the inlet screen to ensure it is not clogged with debris.

• Remove the pump inlet to access the impeller area. Turn the rotor to ensure it is

not broken or jammed.

Back

• Monthly maintenance will add to your pump's life. NOTE: Ensure that the

cover

electrical cord loops below the electrical outlet to form a "Drip Loop." This will

prevent water from running down the cord into the electrical outlet.

AERATION KIT

NTAKE INSTRUCTIONS: The Venturi

intake provides air induction when

the airline is connected to the small

air intake port on the included hose

fitting. Attach the air muffler to

the air control valve using the tube

connector.

Attach the air control assembly to the

Venturi air port on the included hose

fitting. Keep the air valve and muffler

assembly above the water surface

level. This pump can be used with or

without the Venturi air intake.

EDGE OF TANK

MUFFLER

AIR VALVE

CONNECTOR

AERATION KIT